char junk;
String inputString="";
void setup() // run once, when the sketch starts
{
Serial.begin(9600); // set the baud rate to 9600, same should be of your Serial Monitor
pinMode(13, OUTPUT);
}
void loop()
{
if(Serial.available()){
while(Serial.available())
{
char inChar = (char)Serial.read(); //read the input
inputString += inChar; //make a string of the characters coming on serial
}
Serial.println(inputString);
while (Serial.available() > 0)
{ junk = Serial.read() ; } // clear the serial buffer
if(inputString == "F"){ //in case of 'a' turn the LED on
digitalWrite(13, HIGH);
}else if(inputString == "B"){ //incase of 'b' turn the LED off
digitalWrite(13, LOW);
}
inputString = "";
}
}
No comments:
Post a Comment